ESTONIAN ACADEMY
PUBLISHERS
eesti teaduste
akadeemia kirjastus
cover
Estonian Journal of Engineering

Effect of oxidation on abrasive wear behaviour of titanium carbide based composites in silica medium; pp. 264–272

Full article in PDF format | doi: 10.3176/eng.2010.4.02

Authors
Maksim Antonov, Irina Hussainova, Jüri Pirso, Mart Viljus, Kristjan Juhani

Abstract
The aim of the study was to investigate the effect of oxidation on the behaviour of TiC-based cermets with Ni-Mo binder under low intensity wear conditions in silica sand medium. Three types of material performance maps were constructed: oxidation rate map, wear rate map and map showing the effect of oxidation on wear. Discussion on the performance of cermets is based on oxidation, wear, SEM, EDS and XRD results. It is shown that cermets behaviour is highly influenced by microstructure (Ni, Mo content and Ni:Mo ratio) and oxidation kinetic. The paper should facilitate the optimization of TiC-Mo2C-Ni cermets selection for room and high temperature wear applications.
References

1. Wang, B.-Q. and Luer, K. The relative erosivity of limestone, dolomite and coal samples from an operating boiler. Wear, 1998, 215, 180–190.

2. Antonov, M., Hussainova, I., Pirso, J. and Volobueva, O. Assessment of mechanically mixed layer development during high temperature erosion of cermets. Wear, 2007, 263, 878–886.

3. Brookes, K. Nano carbides make for low temperature sintering. Metal Powder Report (online magazine www.metal-powder.net) 2009 October, 26–32.

4. Hussainova, I. Effect of microstructure on the erosive wear of titanium carbide based cermets. Wear, 2003, 255, 121–128.

5. Shreir, L. L., Jarman, R. A. and Burstein, G. T., eds. Corrosion. Metal and Environment Reactions. Butterworth-Heinemann, 2000.

6. Antonov, M. and Hussainova, I. Experimental setup for testing and mapping of high temperature abrasion and oxidation synergy. Wear, 2009, 267, 1798–1803.

7. Antonov, M., Hussainova, I., Kimmari, E. and Juhani, K. Verification of new 1000C tester designed for investigation of wear-corrosion properties of advanced materials for high temperature applications. In Proc. 6th International Conference of DAAAM Baltic Industrial Engineering (Küttner, R., ed.). Tallinn University of Technology, Tallinn, 2008, 395–399.

8. Antonov, M., Hussainova, I. and Kübarsepp, J. Oxidation-abrasion of TiC-based cermets. Wear, 2010. Forthcoming.

9. Bradford, S. Fundamentals of corrosion in gases. In Metals Handbook, 9th ed., vol. 13. American Society for Metals, 1987, 61–76.
Back to Issue